Change oil and oil filter in the engine

Change oil and oil filter in the engine car, Mercedes - a very important procedure to maintain, so as pollution and oil dilution leads to the advance engine wear. To replace oil and filter need: Rack (observation well), head for turning the drain plug, sealing washer (copper or aluminum) for the drain plug, the key to reversing the filter, the capacity to drain the oil, as well as replacement oil filter and engine oil, approved by manufacturer Mercedes. A few general tips: 1.Before work lubricate hand barrier cream and wear gloves, as contact with the skin of spent oil is very dangerous. 2.Nikogda not send the waste oil into the sewer system to avoid environmental pollution. 3.Ne mix oils of different types and brands - that's bad effect on the overall operation of the engine. 4.After attach the drain on the engine tag with the date change and oil grade. Oil can be drained from the sump or deflated with the appropriate pump through the guide tube measuring probe (oil level). The first stage of work is to drain the oil. To do this, warm the engine up to operating temperature. Then, using jacks, set the car on the horizontal struts. Under the oil pan to put the capacity to drain the oil, and by removing the drain plug with the key to release oil. Care should be taken so that hot waste oil does not reach the skin. Waiting for emptying the tray, screw the drain plug, after putting on her new O-ring. Put the car in its original position (on wheels). If the oil is sucked out, then began to disconnect the hose between the guide tube level gauge and oil separators with the clamp. After draining the oil, do not forget to remove the clip, because after absorption into the engine it clog the air mass meter. The second stage of the process is to replace the oil filter. First you need to turn out a certain Allen key oil filter located on top of the engine. Then wipe with a rag soaked in fuel landing flange on the engine block and remove from its surface trace of the remains of the old gasket. Before installing the new gasket replacement oil filter is necessary to lubricate it with engine oil. During installation, manually tighten the filter cartridge to tight adherence to the planting strip flange. Make sure that drain plug has been screwed with the required effort. The final stage of work involves filling the new oil. It should be poured through the filler neck on the cylinder head cover. For nedopuskaniya razletaniya spray, use a funnel. Then check with the feeler gauge the amount of oil in the engine: its level should be between pointers «min» and «max». If the oil was in surplus, it must be pumped out to avoid damage to engine components. After the test drive check the tightness of fit oil filter and drain plug. After a couple of minutes after the engine stops running further check the oil level and, if necessary, correct it. High-quality and fast repair Subaru perform specialized experts from the service center Chance. You to quickly conduct a full diagnostku your car Subaru and identify malfunction. Regular customers discounts.