Repair of the generator Nissan Primera own hands

First deprotected at the bottom of the car. This allows unimpeded access to the generator and one for the course to dismantle the radiator. In the case of this model car is a fairly simple process, not a lot of time doing. Further, the radiator must be through the bottom outlet to drain antifreeze, without removing it from the engine. In the future just cover all the pipes. Thus, the cleared space, which is necessary for subsequent work. Before removing the generator, you must unscrew the wire natyazhnik. Excerpted generator placed on the bench for the absence thereof, on the table. Pulley in this case located at the bottom. Then, he removed the cover with the logo "Magnette-Marelli. There, placed brush assembly of the generator. Butt rotor brush assembly protected by a plastic cover, located on the vertical rails. Lift it gently with a screwdriver carefully removed. Carefully inspect the brushes and making sure that they are really worn out, giving way all that is in the process will inevitably interfere. Then brush the node is removed from the generator. Carefully lift the lid on a guide mounted on a sled. Again, carefully inspect the brushes. When emergency worn brushes, and restore the generator in two ways. The most simple-minded way is to purchase another brush assembly, instead of intercourse, and its subsequent installation. Following the instructions, all collected in reverse order. Although, if there are obstacles to the acquisition of a new node, start to his self-assembly of "improvised". To do this entirely amiss brush assembly that is used for generators VAZ. From the generator cut brush directly with copper wires. But be sure to cut with a reserve. Field extracted from the original block brushes, cut them again. The result is acceptable working brush, equipped with "pigtails" tokovodov, as well as a block to the remaining similar tokovodami, complete with terminals. Next, solder them together, bends, and if necessary, customize the size of brushes with emery. Fitting brushes delicate work that requires accuracy, concentration and caution, because graphite is still quite a soft material. The generator was purified from the graphite dust inside. To successfully complete the renovation of brush to gently sink into place with a sharp, but not too hard object, so as not to cause them damage. For further assembly of the generator have resorted to an existing instruction. Upon completion of assembly, place it in the car.