Wednesday, June 15, 2011

Secure replacement spark plugs

One of the easiest operations that can execute each motorist - is to replace the spark plugs. Yet, many cars, modern origin, this procedure creates the whole problem for the driver, and that it will produce a parse almost one half of the car. We return to a simple car, where it is possible to replace the spark plugs with their own hands. The proposed procedure is the simplest way. This happens as follows: you have to disconnect the ignition wires, which is under high tension, and then unscrew the candles, a special wrench for spark plugs. Now, more details on this point. Often, the motor builds up a huge amount of dust and dirt, undoing much of the candle is not desirable bacteria gets inside. Probably not something terrible will happen if a couple of times this happens, but we are constantly changing candle, which means that sand and dirt, there will accumulate with each replacement. After some time on the cylinder gets scratched, as well as the compression engine is reduced, and oil consumption for the motor increases. To avoid this need to take next. To such situations from happening, you need to get rid of them beforehand. First, before replacing the spark needed to clean off the dirt from the motor. This will require high-pressure compressor, using a jet of air to clean all the dirt around the spark plug. More to clean wells of candles in the car will suit bus compressor. if the compressor is not available, then we can resort to using a brush, simply wipe her dust. Even before each installation of spark plugs should be thoroughly cleaned of their wells. For the experienced car enthusiasts, there is another method of preventing the penetration of particles into the motor. This requires a rubber hose, a simple, external diameter equal to 26 millimeters, the inner - 18 millimeters. To cut away part of the width of which will be 5-7 mm so that they may be put at the base of automotive spark. Next you need vvertet candles with his own hand-made rings made of rubber in place. After this operation the well will be permanently covered by adverse factors.

No comments:

Post a Comment