Cleaning injectors with their own hands

Two ways of cleaning nozzle in the home during prolonged operation of the machine, it is necessary to conduct maintenance, which also includes the maintenance of the engine. Cleaning nozzles should be performed every 40,000 miles. run. In addition, if the sudden pressing the gas pedal you feel the dips, or a car jerks and bad going without heating, so too must be cleaned injectors. Many drivers know firsthand that clean the fuel injectors are not as too difficult. Cleaning nozzles can produce so-called "industrial process", which involves the use of ultrasound. But such treatment can only be made in the workshop, and their work is not fully restored. Cleaning nozzles industrial method only improves the dispersity (reduces the size of the drop in fuel atomization), increases their productivity and leads to more of the same petrol consumption among all nozzles in the engine, and restores the torch spray. However, this procedure costs money. Therefore, we can try to clean the injectors themselves. For this you need carburetor cleaner in a spray cleaner, injector, as well as spare ring on the nozzle (which, of course, may not be needed, but will save you from unnecessary trips to the market). Method number 1 is first necessary to goutweed barrel with two nozzles, remove the clamps from the bottom and remove the bracket with the wires from the injectors. On the bar with nozzles need to unscrew four screws and carefully pull off with its nozzles. After that, each nozzle should be pulled out of the queue, but it should be done carefully so as not to damage the nozzle. All shot nozzles must be placed in a container of washing while they are there, clear the spray nozzles. Typically, nozzles around the nozzles are covered by coke, which resembles tar, of course he is removed it is very difficult, but it must be done. When the injector is cleaned of coke to be blunt with a special needle gently clean the surface around the nozzles, formed in the process of cleaning the dirt blow with spray. So, outside of the nozzle cleaned, and now you're ready to wash them inside. This will require a power supply, designed for 12.3 volts, and a foot pump, pressure gauge. With the pump hose should be removed end of the hose to pour cleaner, then put the hose nozzle. The pump should be inflated to 6 atmospheres, and the nozzle to submit three volts (for the first time may need to give one at a time of about 9 volts to injector clicked). Voltage should be sent in portions, and the pressure pump to pump periodically. When all the jets prokachany so in reverse order returning to their seats. Method number 2 The second method is more sophisticated, there will only need a spray to clean the carburetor, which respectively poured into the pump hose. To clean the nozzles from fouling, clean cloth to lightly moisten the spray, and rub her nozzle. From spray nagar softened and gradually cleared.