Painting a car at home

The high cost of repainting the car services often forces many car owners to independently conduct the procedure. Of course, painting the car with his hands will be very different from the manipulations that are carried out by professionals. Just "pour" on the car paint and wait until it is completely dry, will not suffice. It will require the use of special technologies, provide training and use of special equipment. Painting the car should start with his bathing. This will give the opportunity to see all the defects are available on the body. During the movement of sand, stones and other small abrasive "polish" the bottom and the car body. Before painting machines to carry out preparatory work. Depending on how damaged the body, distinguish partial, spot and capital procedure. Here we will mention a radical change in color, ie, painting of the capital. Dyeing machine at home will require a lot of patience: the procedure itself takes only about 10% of the time, while the remaining 90% will be spent on training. When painting may interfere with locks, moldings and seals, so they must be removed. If all of these elements are simply seal the masking tape, then under them can accumulate moisture, which in future will cause irreparable damage to the car. Body of the car intact, shpatlyuyut and soil. The old paint is removed, thoroughly cleaned of corrosion. Before painting works may need welding or straightening. Often rejected by some of the materials produced by different companies. Therefore it is better to use the products of one manufacturer. Preparation of a car consists of five stages: 1. Car Wash by the use of shampoos. Removing dirt and conduct initial training. 2. Degreasing body surface, removing grease and asphalt patches. 3. The elimination of corrosive lesions. The old paint is removed using the method of abrasive grinding. Abrasives could serve as silicon carbide and aluminum dioxide. Paper for sanding should be selected on the basis of "difference" numbers, it should not exceed one hundred units. Material may be subject to subsidence, if we use paper that is not "room". 4. Conducting primary and secondary primer, which creates a corrosion-resistant coating on the body. Drying of the soil can last from 2 to 4 hours. 5. The final phase consists of applying enamel and lacquer. Direct painting car painting car consists of applying three coats of paint. Apply the paint will be easier to spray. Items that are not exposed to paint, need protection. This may go paper, tape and plaster. Also, places such a body can be coated formulations, carried out from the chalk, water, glycerol and dextrin. But we need to ensure that the composition did not fall on parts of staining. After painting this composition can be easily washed off with water. After the first layer of paint can be applied by the other two layers. But the enamel composition should differ from others. Follow-up procedures allow the use of more liquid paint. Varnish will give a bit of gloss and color in this case, get rich and deep.