Polishing headlights with their own hands

During the operation of the vehicle under the influence of the environment the degree of transparency headlights much worse, rocks and sand left on the glass optics are numerous scratches and mikroskoly. In the damaged area of ??glass falls into the dirt and remove it quite problematic. Cloudy glass lamps are much less pass the light and scatter it wrong. As a result, light vehicle is reduced and this leads to a decrease in the safety of your vehicle and others. Fix this problem can be acquiring a similar glass to the Russian car, but here's a car which mounted the block lights, this is not possible. Cost disposable lights are quite expensive, and the model out of production they do not get it. On many models produced in recent years, glass lamps are made of plastic and restore the capacity of lamps can be easily enough. And it does not require you considerable expense. Offered by different craftsmen how to restore the transparency of glass such as: scraping with a razor, rubbing GOI paste or tooth powder, provarivanie in oil burning or open flames can not stand nor any criticism. There are other ways to help you achieve good results. The most popular and affordable way is to polish glass headlights. Many companies offer to perform the procedure to restore the transparency of glass lamps, but prices in this exhibit comparable with the acquisition of a new product. At a cost about 20 rubles, and the presence of American low-cost equipment can perform these operations are repeated as necessary. What is necessary for this? In the beginning, you must purchase Abralon - this abrasive material with different grain size. Completed it on the basis of soft tissue and has a foam backing. Just need to buy wax for final finishing. Experts recommend polish Polish-2000. Still need to soft tissue and normal construction adhesive tape to protect adjacent components. Circles Abralon have Velcro for attachment to the grinding machine or a conventional drill with these electric machines to polish will be much easier and faster. Can be carried out and polishing by hand, the result is good, but would require considerably more time. Foam substrate is smooth over all the bumps on the fingers and palms, and repeat all the contours of the headlights. Before polishing glass lamps, must be washed thoroughly, and seal, with construction tape, land adjacent to the lamp. Automotive parts, which are taken to dismantle the best. Initially a rough sanding with circles Abralon-600, which, before beginning work properly moisten with water. So work will be much easier as dirt when it remains inside. Time on this stage takes only 2-3 minutes. After completion of this phase, the surface lights should be brushed. Then you should rinse thoroughly with water to remove the spotlight abrasive and start consistently perform polishing headlights circles 1000, 2000, 4000. Each of these steps to perform no more than three minutes. Upon completion of these operations spotlight should be almost transparent. Inflicting on the rag a little Polish-2000 polish hand washed and slightly damp glass. To this work will require a little more than 15 minutes. The result will be visible immediately. Farah will look like new. Checking on the devices, too, confirms this, lighting should noticeably increase. If you do not practice for such works, then try to advance this operation on a broken or non-recovery of lighting devices. With a little time and resources required to run gain work experience.