Custer - the eternal problem

In the case of disposing the car to the side, check the caster, which in classical Zhiguli determined by the geometry. Caster is adjusted by adjusting washer, which is installed between the beam and the bottom axis of the lever. To change this, simply rearrange the required number of washers from the front to the rear bolt, we can and vice versa. The main thing to keep in mind when adjusting caster, change the collapse. For the work we will need a device that we can make for yourself. It consists of two channels, which are connected by four bolts through the gasket. On one side we drill a hole under the hub cap. On the other side of the device is attached protractor and plumb. Get to work. Put the car on a horizontal surface and removing the wheel, we omit the lever of the suspension on any stand. Next, unscrew the pins. We are consolidating our manufactured product on the wheel hub and it is adjustable lamp, which must be adjusted for comfort. We then cranking the hub and brake fix its position (as you know, an assistant is required). Adjusting the position of the lamp, direct the beam toward the lower support. If it misses the center (which would be good to mark, well, for example, an arrow on the magnet), whereas there was a strain knuckle, and perhaps most lever suspension. In this way, checking the accuracy of the set design (and, if necessary, replacing broken parts), using a protractor and plumb line with the risk measure caster (ie the angle of longitudinal inclination of the axis of rotation of the wheel). If need be, remove or add washers adjust the axis of the lower arm. Install onto your vehicle immobilizer quality of the foreign producer and sleep soundly. The system reliably protects your car against theft. A quality installation can proizvezti specialists from the center AvtoStudio.