Tinted car windows with his hands

When Tinted windows motorists car driven by different reasons. But we want you to list the 6 main reasons for deciding to tinted windows. 1. Reduced heating the car up to 60% in hot weather. 2. Protection from possible skin cancer, because Tinted delays 99% of UV rays. 3. Tinted side windows keeps crashed, protecting you from cuts in the event of an accident. 4. Protects from harmful glare of the sun, oncoming headlights of a car and snow. 5. Hides the contents of the interior from prying eyes. 6. Protects the inner lining and plastic car from harmful sun rays, because they can burn and crack. Toning is made by attaching to the car window a special film. It is made of transparent polyester film on which the cause of a special metal and paint. Many believe that dubbing the film is too dark and there are problems when driving at night. But this is not true. Each film picks up with the required degree of dimming and to the same film reflects only the reflections, and the visible light passes. The film is mounted on the inner side of the automotive glass. If it is stuck on the outside, it may be subjected to mechanical damage, rain or snow. If you decide toned glass of your car, remember that in Russia prohibits tinted front glass film with transmittance below 85%. Before bonding the film to clean the glass surface from grease and dirt. On the glass surface should not be chopped off. Otherwise, in the bumps will form air bubbles. Hardest tinted rear glass, especially if there are installed blowing glass or stoplights. To make it easier to apply shading, some people take out the glass and run on your desktop. Can be carried out without removing the tinted glass. To do this, apply a papyrus paper to glass and depicts his path. After the cut pattern and drag it on tape. Cut film along the patterns. Next, wet the glass with the inside of the soap solution and apply the film. Tightens the tape on the ends to make it, exactly lay down on the surface. If possible, do not touch the film in the middle, otherwise it will wrinkle. After you install the film to sprinkle the surface of adhesive solution, paying particular attention to its edges. Once the film will fall perfectly, take a towel and remove excess mortar. Very gently pushing, keep the air bubbles and the remaining liquid, if any, to the edge. For best results, you can take a heavy object, and wrapped in a towel, smooth the surface of film dubbing.