Front bumper of his hands

Front bumper with his own hands Have you ever wondered whether it is possible with the help of mikrofleksa and putty to do with their hands bumper? It turns out that it is possible! This idea may be quite real, and the strength to everyone. We need only a little patience and exert the maximum skill. The first thing to do is remove the bumper, bring it to the garage and placed on a workbench. Then take a few pieces of foam and glue them on both sides to the bottom of the base bumper. Middle part of the necessary glue with masking tape and put on her future markup bumper. Then, partitioning, glue pieces of foam. To makrofleks not trickled down on the edge need to fix pieces of foam. Use for this can be masking tape. Cardboard will be playing the role of the grounds on which, while not completely harden, will hold makrofleks. After attach foam with makrofleksa have to fill all the vacant space between the foam. It should be borne in mind that makrofleks tends strongly to swell, so a layer of filling should not be large. After that, extra pieces of cardboard can be removed. Then, using the nail file and knife, you must give the necessary form for tuning bumper. This is done quite easily, as makrofleks lends itself well to cutting and it can define any shape. Next you need a tape. Take a roll of this material and prokleivayte them all the bumper, it's better to do it in several layers. Tape must be put on top of a layer of foil and put together with glass, a layer of epoxy. This composition should be applied layers, allowing each layer to dry well. Then, when everyone finally got a grip must disconnect the resulting blank fiberglass bumper, and the edges neatly trimmed. Place of contact with the workpiece, on the bumper, retarding, using the cutting device and make a notch in the grid, so that the glue is well captured. Having done all this, we can apply the workpiece. With the help of adhesive tape is necessary to fix the workpiece on the bumper, and then start prokleivat her glass, simultaneously impregnating epoxy resin. Layers of fiberglass should go lap bumper to harvesting reliably detected. For reliability, you can attach a piece on the bumper by riveting. Now you will be one of the most labor-intensive work. It is necessary to apply a coat of filler, while aligning it. Small layer is applied to the well-dried surface. Once you level the surface, start sanding it. Start with coarse sandpaper, gradually moving into smaller skins. After the surface is polished, apply a coat of primer. When finished apply a layer of soil, let it dry out a bit and, as a final step, apply the automotive paint and then uniform layer of lacquer. After the paint dries have the whole piece, now finally, polished. This completes your work is finished. After the procedure you get a bumper, which is sure the store can not buy.