Car stickers film with his own hands

Now there are many ways to give your car a unique, recognizable look. Quite a number of special workshops dealing with the tuning of various complexity and different direction. But as a rule, services such services be expensive, and sometimes there is no need to radically change the exterior of the car, and there is a goal just to make it different in the traffic, or emphasize one or another of his dignity. In such cases, often costing pasting different body films are sold in specialty stores. Of the many types of goods offered, you can choose stickers of various themes and artistic execution. There will be words or pictures - a matter of taste car owner. Typically, demand picture, emphasizing the character of the owner, as well as supporting a variety of sports memorabilia. But is it worth to consult specialists in this case? Can say with confidence that the process of laminating film car you can learn on their own, a little sorting out the technology and a minimum of effort to carry out these works do not require special tools. Everything you need to cook - it's a knife, scissors, squeegee (plastic and felt), spray, filled with detergent diluted with water (1: 10), an industrial dryer (which is industrial) and the label itself. The easiest way to use one label, which is sold in a set of conveyor belts and a squeegee, but in the case of pasting of copyright products, will have to buy them separately. Consider the process of gluing. To work better together. Clean surface to be processed degreasing solution and calculate the position of labels on the surface, putting the overall and intermediate marks which need to be guided, pasting the image. Smoothing out the film on a flat surface, remove the vinyl layer with the basics. It should be remembered that the adhesive coating is very strong, so you need to immediately process it from the dispenser. This will avoid the bonding adhesive surface with awkward movements. While a partner keeps the sticker in expanded form, processed portion surface of the car to be coated image. Then superimposed image and the center is rolled with a roller. Should be careful not to crease and left bubbles. Film, thus, necessary to heat the dryer, but without much effort, since there is a risk to deform the image. After graduating from papering the entire surface must be dried. At the final stage will once again rolled a felt squeegee the entire image, eliminating wrinkles and bubbles. If you can not correct the defect so that you can pierce the swelling with a needle and expel moisture or air, then dried again. Small pockets to pay more attention should not be - they will disappear. Preferably during the day does not go by car, giving the maximum label stick to the surface, after which it bears re-examination of images and another treatment squeegee.