Padding of the car doors with their hands

Any car's interior can tell a lot about their owner. About all his bad habits, those that can leave an indelible mark on the upholstery of the passenger compartment, on the preferences and tastes of the owner. In a car may make changes in everything: from the interior of the car interior to the technical characteristics and appearance. In the operation of the car, the car owner will eventually notice the tears, abrasions, hardened doors, seats and upholstery. Much faster than it does with light salons. To return to the purity of his interior can, of course, apply to dry cleaning, but sometimes, it's a good result will not. You can buy new covers on the seats, but the door inserts and ceiling covers not hide. But the decision is, it is to pull the door inserts interior. Of course, you can contact the showroom, but you can spend the whole procedure very own hands. And it will be much faster, and most importantly - cheaper. With the help of the constriction is not only possible to return the original, aesthetic appearance, it is in that cabin will be much more convenient and comfortable. Not unimportant, and that it will be proud to host, as he did with his hands. Constriction process should start with replacing the door skin. A lot of effort, as well as the time it is not required. To begin, we will have to buy fabric, glue, brushes and a few screwdrivers with different diameters. And a screwdriver must necessarily be with a bent, 90 degrees, the end. It is necessary to fill the cloth. We first remove the old door trim, clean the inside door of dirt and dust. You can trim and glue on the old paste made of cardboard, but it is better to replace these inserts. To form was correct, then attach the fabric to the door and cut along the contour. Then cut the contour of the door handle. Using a screwdriver, the end of which is bent, tuck the fabric under the covering. Then gently Draw a pattern on the contour skin, not forgetting to leave the seam allowance on all sides. After this, align the fabric. Next, apply glue - Near the edge of the door, along the contour. Using a screwdriver, tuck the fabric inside the door. During this work the material should always stretch and stretch to avoid wrinkles and folds, and the very fabric lay flat. If you do not have the glue, then use screws. Then find, where the windows and in the tissue beneath it, cut a hole diameter required. There is another way - the fabric can not cut, and push the fabric, cutting it into pieces, so then fold the edges inward, with a face. After that, carefully glue the edge of the fabric with a face on the reverse side. At this constriction over the door, you just have to put in place the door. The same principle can be trim and front door. Then, when you drag the door, then proceed to the waist plating armrests. Not to disrupt the overall interior color scheme, color plating armrests should be in one color with a shell doors. But as in the armrest includes several parts, it can also consist of two colors.