Painting a car body with their hands

To prepare and paint the body will need: - Primer - a two-component putty - sanding paper (coarse and fine) - "taped" for sandpaper - solvent - "Sadolin" - White spirit - paint gun - cotton fabric - shoulder blade for mixing paints - glass jars with tight-fitting lid. It often happens that the redecoration of the car body is not enough: the paint ages, and the car immediately loses its beautiful appearance. In such a case is already necessary to fully paint the body. Painting the body on its own - it is very subtle and complex, but nothing is impossible does not happen. Begin work needed to washing and drying machines. For convenience, you can parse the body. If you decide not to disassemble the body, then you should take care of the parts that do not need to paint and to close them with paper or cardboard. After that we remove the rust, but on the clean surface impose a thin layer of primer. Next you must remove the old paint. This can be done in two ways: manual and chemical. In the manual method used sandpaper, brushes or scrapers. This option is not complicated, but very time consuming, especially for cleaning hard to reach places. But with the help of various means of washing away, you can ease the task, they are able to soften the old paint. In addition, these compounds can be prepared independently. For example, take the crushed wax at a temperature of 70-80 degrees to dissolve it in xylene, in the proportion 1:4,5. When the wax melt and become liquid and transparent, you need to cool it to 40 degrees, and then add acetone, about 4.5 parts, then put the mixture to cool to room temperature. The prepared solution should apply a thin layer on a clean surface and wait 15-25 minutes. After that, the paint wears off and you take away her spatula and wipe clean part of the body. The remaining paint and rust is removed with sandpaper. Removal of corrosion can do more with rust converter, usually a water - alcohol solutions of phosphoric acid doped with corrosion inhibitors. After surface treatment can begin priming. Once you've removed the paint and rust, you need using the white spirit degrease. Next the surface must be smoothed. This is best done straightening. Then should be applied on a flat surface fillings, it must be applied very thinly. Subsequently, drying, surface must be degreased again, and then primed. Now of course you can go to paint. First, plot the initial layer on which you will immediately see all the bumps in the zashpatlevannoy of the body. Painting can be done with a vacuum cleaner. Only need to fill the tank with approximately 100 grams of solvent. And then you have to adjust the vacuum cleaner and pour it diluted the paint. To avoid stains, paint should be applied with horizontal, fast movements. Then 20 minutes later, you can apply a final coat of paint. After the whole process, you need to leave the body dry. This will last for several days. Leave it in a closed room, for example, in the garage.