Painting wheels with their hands

A good appearance of the car depends on many factors, which include the state of its wheels. Unfortunately, the car parts can be damaged or damaged by a large number of external factors, which will leave a negative mark on the cover disks. The spring season began, and therefore, all motorists think about how to fix their car and improve it. There are many ways of painting wheels and, in principle, they are not quite sophisticated. Typically, color wheels on one side and makes it easier to work with painting. Initially be removed from the wheels wheels car, then wash, dry and remove the old paint, if it has remained. For this process there are various solvents. In order to mitigate the nitro you'll need gasoline. Be careful not to fall into the rubber solvent. Next to water surface and allow the paint to soften it, and then using the drill with a special nozzle gently remove the old layer of paint. There are some remote places where the paint off does not work, so you need to use an awl or screwdriver. To clean the disc before daylight, you need to apply the wire attachment on a drill, it will remove even rust. After all procedures, the disc should be treated with gasoline or solvent, and dry place. Now prepare the paint for painting drives. It all depends on your personal preferences, but rather that the color of the disc was similar to the original factory settings. To date, sales are a variety of colors and shades, enamel and pearl. Choose a color for your car drive. For example, enamel fit perfectly on the quality and cost it cheaply. After that, you need to prepare the paint for the job. You should not mix with other types of enamel paint to the surface of the disc has not lost its luster. Two cans of enamels, you will be quite enough to paint a 2-3 sets disks. If you have one tone paint, then it's all elementary, and if the two tones, then it will be difficult. Suppose you have a black and white enamel. Take a glass quart jar and pour back the white paint, slightly more than half and at the same time, do not forget to stir the paint stick. Then add the black paint and all the while stirring. Stir the paint and see what color we have. If you have not reached the desired shade, then add more paint desired color. Painting should be done by spray or brush. Before painting to all pasted masking tape, and if the paint got on the rubber, just have to wipe it. When painting with a brush, paint must be thinned with solvent, it is done in order to not leave brush marks on the disk surface. With careful work with brush painting is not how it is worse than dying with spray. In the end, painted wheels, it is necessary to dry in air for one day.