Repair Nissan Almera with their own hands

In our time, car owners do not think much about repairing the car with his hands. Large contingent of service stations of both foreign and domestic producers will not leave drivers in the lurch. In addition, the SRT is always ready to help if your side does not find car services. In spite of this, every motorist should be able to fix minor damage on their own. Just below are examples of how you can fix minor problems on the Nissan Almera. - Do not start the engine. Immediately check the oil level dipstick: the level should be, is between the minimum and maximum temperature. In the space under the hood should not be a drip oil, coolant or fuel. Pay attention to the wiring and a good connection with the ignition coil and spark plugs. If during the inspection you find that the candles are filled, do blowdown cylinders. To do this, turn the starter when wrung out the gas pedal. Due to this there is no fuel supply, and from the air cylinder frequent remnants of gasoline - candles dried. After that, you run the engine normally. If the engine fails to start, then broke down the system start-up, power or ignition. In this case, without skilled care is necessary. - Missing idling. Very often this problem occurs due to sensor throttle position. The reason may be clogged valve or air suction. In this case, try changing the sensor, clean the throttle, tighten clamps on the tubes - if the result is zero means necessary to replace the whole throttle assembly. - Oil pressure dropped. If, during engine operation does not go out the emergency lamp oil pressure, switch off the engine. After cooling the engine check the oil level in the crankcase. Note that if out of the crankcase is not flowing. If you found a leak in the pan, it can be repaired with a rubber stopper or cold welding. Also check the tightness of the Pancake filter, and does not imply whether out of it oil. Oil pressure can be checked by a mechanical gauge. If the growth of the engine speed increases the pressure on the gauge, it indicates a failure of the sensor or its circuit. - Stalled the engine. The main reasons - it is a system failure or power plugs. First, check availability of gasoline in the tank. Inspect the space under the hood: there are no stains on the fuel hoses or burnt wires. Check the oil level, as well as the liquid in the expansion tank cooling system. Check the timing belts - it may be due to breakage. Note the position of the crankshaft and its wholeness, connection boxes of wires to the sensor - it may be another reason for stopping the engine. In one short theme is very hard to tell about all the ways to repair Nissan Almera. Typically, the skills come with experience, so do not miss any detail of the mind as well try to learn from their mistakes.