Brakes, one of the most important systems of our car and, therefore, its condition must be kept under control. Now you will learn how to carry out pumping hydraulic brake system in your car Lada Priora. Pump hydraulic brake system should be in if it got the air due to depressurization. If the air crept into the system, then you can learn it at once, poor braking qualities of an automobile: the pedal will increase your speed and go soft or become more rigid and reduce speed. If you notice these pranks from your car, do not tempt fate, and bleed the brakes. To carry out pumping, you will need these tools: rubber hose, tank drain brake fluid and a wrench to 8. A pump the brakes must be in the following sequence: first, back right, then the front left, rear left, and finally front right. Process Flow: Top up the brake fluid reservoir brake cylinder to the level of max. And the fluid must be of the same manufacturer as that found in the tank at the moment. Set the machine to the observation hole. If necessary, unlock the rear brake pressure regulator by inserting a screwdriver into the space between the piston and the plate. Clear vent valve on the brake. Remove the protective cap. Put on one end of rubber hose to the valve and the other end to put in the tank, which is partially filled with brake fluid. For this step you will need an assistant. Let it be sharply put pressure on the pedal 5-6 times, and after the last time to leave the key. Unscrew the vent valve half a turn, the resulting liquid will be visible air bubbles. When the fluid stops flowing, it is necessary to close the vent valve and the helper can release the pedal. Repeat step 7 and 8, while the bubbles are completely gone from the flowing fluid, parallel to pouring oil so that it is not dropped below min. Remove the hose and wipe dry and put on a choke valve cap. Pumping over.
No comments:
Post a Comment