Repair steering rack Ford Sierra

If a car steering Ford Sierra came a nasty knock and increased backlash, it's time to do repairs steering rack. This work can be done on their own. To do this, set the steering wheel in the drive position "as the crow flies." Unscrew the bolt clamping the holder flange elastic coupling and disconnect the steering shaft from the drive pinion steering transmission. Raise the front of the car and set it on cooked trestle. Unscrewing the nut of the hub, remove the front wheels. Extract the pins from the steering pins and unscrewing the nut for pivot steering rods. Applying puller, disconnect the tie rods from steering knuckles. Unscrew the mounting bolts from the steering rack to the front beam and extract the steering rack. To replace worn out parts of its rail must be dismantled. Begin with, disconnect the ball joints from steering rods, raskontrogaiv them. Remove clamps attaching protective covers and blankets from the body shifts the steering transmission. Toothed bar moves to the left until it stops and, through the aluminum strips, clamping rail in a vise. Tie rod unscrews from the rack, remove the tappet cover with lid Steering and extract out the sealing gasket, shims, spring and plunger. Remove the cover drive gears, together with its gasket. With shaft drive gear bearing shoot. From the shell extract Steering rack and nylon guide ring, located on the right side. Dismantling the steering gearbox, purify it part of the dirt and old grease and inspect the technical condition of all its parts. Detail, with extensive wear and tear, replace with new and start assembling the steering transmission. Begin with the installation of a new building nylon guide rings. It is installed on the right side. Toothed bar is inserted into the body and set it in the middle position. Now you can install the drive gear with bearing. Install the gasket and the cover drive gear, set in place the pusher, the pusher spring, shims, gasket. Tighten the bolts fastening the cover and make sure not too tight collected works construction. Tightening the rod, put a new cover and clamps, steering joints, install the steering gearbox on a car. Quality and affordable Volkswagen Passat Parts for your car. Direct delivery from leading manufacturers in Germany.