Durable foreign cars, but when the car is already more than dvadtsatipyati years, should be ready for the inevitable repair of a unit. Particularly affected by the age of rubber parts, in particular, rubber protective covers rear spindles car Ford Sierra. Subject to certain rules it is quite possible to perform such work themselves. To do this, hang out on trestle rear of the car and remove rear wheels. Dismantle the brake drums. Unscrew the nut holding the flange of the hub and using a special remover, remove it. Unscrew the four nuts that secure the hub of the wheel to the rear suspension arm. Remove hub and bearing disconnect the brake shield. In order not to disrupt the compound brake system that carries the backing plate is attached with two bolts to the arm rear suspension. Now you can learn from the rear axle gear axis. The same front will work and on the other side of the car. In carrying out these activities should be aware that trehplechevye hinges semiaxes can not be rotated relative to each other at an angle greater than thirteen degrees, so as not to damage them. Work with the covers from the vehicle axes easier to carry on the work bench with large plumbing vise. Begin dismantling the semiaxes of lifting clamps that hold the protective covers hinge axis. The casing is cut and removed. Remove the hub axis with the hinge, using the device for compression springs. Remove the retaining ring, protective cover to move along the axis and remover remove hinge. Remove gasket and cover and a rubber protective cover. Extract from the hub round rubber ring, and all parts are cleaned of dirt. Having culling unusable parts, replace them with new ones. Getting the assembly axis. To do this, set the axis on the protective cover, gasket, the convex side of the hinge and use the bush, set in place trehplechevoy hinge. Make sure that both the hinge axis was shifted relative to each other at an angle and sixty degrees. Install the retaining ring. Device compresses the spring and put in place the hub axis. Lay in the joint for about fifteen grams of solid lubricant and put a rubber ring on the hub. Install a metal casing, it compresses the perimeter, fill joints lubricated and close rubber covers. Today the painting is very expensive. Therefore, many motorists want to save money and do it yourself. In general painted the car with their hands rather laborious process. Get complete information you can on the site avtopokraski.net. After reading the material you can paint the car yourself and quite good.
No comments:
Post a Comment