Adjusting the clutch mechanism NIWA 21213

Distance between piston master cylinder and a pusher, you want to fully integrate the clutch must have a distance of 0,1-0,5 mm, if it does not match the testimony, it is required to perform the following work. Relax key 10 of the coupling nut at the same time withhold key constraint, the same size. After that, remove the tip fitting cylinder and pulling on the hose fitting to the end of which is lowered into a container with brake fluid. Fitting turns away three-quarters of turnover. At the same person in the cabin quickly presses the clutch pedal and quietly let go to what would have disappeared bubbles, isolated from the hose. While holding the clutch pedal wrap socket and remove the hose, put on a cap. Next, key in 10 unscrews nuts clamp barrel body and remove the tank. Set the tank in reverse order. Fill the brake fluid and re-pumps drive clutch. Remove tank clutch turns away tank lid and a rubber pear from the barrel drains all the fluid. Loosen the hose clip fasteners, remove the tube from the tank fitting. Remove the master cylinder clutch first remove the plastic tube with a nozzle main cylinder. Fluid from the barrel merge into a container outstretched in advance or clog hose hole plug. The key to unscrew the tip of the tube 13. Lower nut too head turns away from the extension. Remove the master cylinder with studs. If you want to replace first remove the fitting or the seal with a screwdriver poddevaem and takes out a lock washer. Then remove the plastic fittings with rubber O-ring. Fitting installed in the sequence reassembly. Work is performed in an observation pit or on a lift. Removing ottyazhnoy spring. Pliers pulling cotter pin from a hole in the pusher. Head of 13 shooting bolts that attach the cylinder to the clutch. The key 22 turns the cylinder in the cover and hold a key for 17 end of the hose. Turn off the key at 13 receiver, hold the upper end of the tube key 19 mm. Pliers remove the retaining bracket of the hose and take out the upper end of the tube. The key for 17 shooting from the hose end cap of the working cylinder, holding it from turning the cylinder, after which the hose is removed. Hose assembly in reverse order. Catalog of CDs and selling tires online store Whisperwind Shin. Here you will pick up the rubber on the car of any type. Large selection of rubber from domestic producers, as well as leading foreign companies. In our shop you easily will choose the right size wheels.