Brake master cylinder (GTZ) and / m Toyota Vista to 95-th at

Disconnect the sensor electrical connector emergency brake fluid level. Remove the liquid from the tank, the brake system. Disconnect the brake pipes from GTZ with the help of a special key. Remove the master cylinder. Unscrew the 3 nuts and remove the cylinder mounting tee braking system. Remove the lock, then the GTZ with the vacuum brake booster and remove the gasket. Loosen the bolt of the brake system reservoir and remove the tank. Remove the lid, filter, and 2 O-rings. Pinch the GTZ in a vise. Using a screwdriver, completely drown the cylinder liner, remove the retaining bolt and remove it along with the gasket. Remove the pistons and piston return springs from the master cylinder. Utopia is a piston with a screwdriver and pliers to remove the retaining ring, remove the retaining ring. Lay the cloth on two wood blocks and easily tap flange GTZ on them until the piston pops out of the hole of the cylinder. Pull the plunger arm is strictly along the axis of the cylinder. Check out the technical details of the state. Inspect the cylinder mirror for rust, scuffing, scratches, traces of high wear or other defects. If such damage is present, GTZ is to be replaced. Apply lithium grease to glycolic O-rings. Install the pistons and piston return springs. Insert the pistons and piston return springs, directing them to strictly along the axis of the cylinder. Drown the piston with a screwdriver and install the retaining ring with the forceps. Using a screwdriver, completely drown the piston and install the retaining bolt with gasket, and tighten it (10 Nm). Set 2 O-rings. Clean the groove under the anther on the flange of GTZ. Make sure that the anther is marked "UP" facing up. Adjust the length of the rod vacuum brake booster. Install a new gasket, cylinder, tee and clamp on the vacuum brake booster. Install nuts and tighten them GTZ (13 Nm). Connect the brake pipes to the cylinder, tighten the flare nuts (15 Nm). Connect the sensor electrical connector emergency brake fluid level. Fill the brake fluid reservoir and bleed the brake hydraulic system. Check hydraulic brake system for leaks brake fluid. Check the adjustment of the brake pedal.