How do I replace the carburetor on the car VAZ own hands

This exercise is not difficult. Doing this work once the second time tips is not required. So you've decided to replace or clean the carburetor itself, it needs to: reduce prolonged clamp and remove the crimp, hose for air intake pipe from the thermostat. Next, remove the air filter, for this we need the key to the 8, they need to unscrew the 4 nuts that attach the air filter housing to the carburetor itself. Sometimes it happens that the loosening of nuts, they slip and fall, so it's best podstelit clean cloth to unscrew the nuts do not accidentally drop into the intake manifold, and then need to remove the plate. Loosen the clamp and remove the crankcase ventilation hose from the pipe. After this work is necessary to remove the air filter itself. Then again need to switch to 8 who need to loosen the bolt tightening fastener membrane tether drive choke, then gently loosen with a screwdriver tightening screws holding the cable, and the need to hold the nut 7 and the key to pull the rope. Further work is taking off with a hose fitting tap the gas, then you need to remove the tips of two wires on the output of micro system management idle economizer. Further, poddevaem screwdriver and remove the rod in the form of a wire with a throttle valve lever. The next stage - a withdrawal of the hose of the electromagnetic valve control system with idle economizer economizer fitting. Loosen the clamp and remove the fuel hose to the carburetor. Now you need to remove the carburetor itself, this would require a key for 13, they need to unscrew the four nuts - it's fixing the carburetor to the intake manifold and remove the carburetor from the engine. All work is to remove the carburetor from the engine is finished and you can easily start the installation of a new carburetor, but need to install a new carburetor in reverse order, so that would not constantly look at the installation instructions, it is best to remember the order removing the carburetor from the engine. And, most importantly, laying under the carburetor must be replaced, but when you install a new carburetor, it is very important not to put more effort to tighten the nuts to the carburetor intake manifold. As you see, is not difficult to carry out work to replace the carburetor. If you have not set a new and clean the old carburetor, then after described removal of the carburetor from the engine itself must parse the carburetor, clean all parts, wash with gasoline, blow, check the floats, springs, needles, and if all goes well, carefully gather and install in reverse order. Basically, carbs are cleaned after use is not high quality, dirty gasoline. At the bottom of the carburetor is the so-called sump that collects dirt. Often, the carburetor goes down, if gasoline hits the water, another reason for malfunctioning carburetor, can become contaminated filters. But if reason is not in gasoline and in the filters, it is best to replace the carburetor, and put new filters. Do not forget that the carburetor is adjustable bolts for the fuel to be adjusted, so that when the engine was the right fuel. When you replace the carb do not be afraid that you are not able to do the job, follow the tips above and remember the sequence of removing the carburetor and all you get. Good luck! In Avtoalians you can buy a nissan teana at reasonable prices. Dealer Managers will help you select the desired complete set, at the request will test drive the car. For all the cars there is a guarantee. You can choose the most flexible equipment.