How to replace front brake pads on Toyota Corolla?

The following describes the process of replacing front brake pads for the car Toyota Corolla. The first thing we need to loosen the caliper, using the key "to 12" Then you should make an untwisting the caliper bracket, with the pads, using the key "to 14". And then make measurements of the thickness of the disk, it should not exceed 8 mm. After which the caliper hang the wire to the spring, the purification of spray cleaner for brake use, then coated with a protective compound against corrosion. Next, you must remove the rails, put grease on them and after these manipulations immediately reinsert it. Compares the old with the new pads. After that you should perform cleaning staples of dirt and should be covered with a special compound must also perform the purification, after which the high-temperature grease to lubricate the bearings. Next set the pads in place, tightening the caliper bracket using the moment 47 Nm, and the slide - 27 Nm. After you install the wheel on the car, fasten it with glue moment 103 Nm.