Thursday, June 23, 2011

Replacing the timing belt (Toyota engines (V6) 1VZ-FE, 3VZ-FE, 2VZ-FE, 4VZ-F)

Disconnect the battery. Disconnect the drive and the vacuum tube cruise control system (if installed). Without disconnecting the hoses, remove the power steering reservoir. Apply the parking brake. Raise the front of the car and set it on the supports. Dismantle the front right wheel and podkrylok right front fender. Remove the drive belts power steering pump and alternator. Supporting the engine, remove the right site of its attachment and brackets. Loosen bolts and remove the timing belt and the right motor bracket. Remove the spark plugs. Install piston (first) at TDC compression stroke. Check whether the timing belt installation of four marks. If they are worn out, then put a new one. Ensure correct alignment of installation marks on the camshaft pulleys. Loosen the tension between the camshaft, a little turning right pulley clockwise. Remove the timing belt with pulley and the camshaft themselves if they are worn out or damaged. Remove the cover from head to cylinder block. Hold the camshaft with a wrench for Allen, loosen the pulley bolt. Remove the bolt and remove the pulley. Remove the guide roller. Remove the bolt that secures the crankshaft pulley. If the pulley has been on the crankshaft, use two screwdrivers as levers. Before you undertake the installation of new belt, remove all dirt and oil from the zone of the drive. Align the keyway crankshaft pulley with key crankshaft pulley and install the flange to the engine. Replace the tensioner roller, washer, and insert bolt. Tighten the bolt to the specified torque (35 Nm). Install the timing belt, starting from the crankshaft pulley. Install the belt on the tensioner and water pump. Install the belt, the bottom cover and gasket. Fit crankshaft pulley, aligning keyway pulley with key crankshaft. Install bolt and tighten it with a moment of 250 Nm. Install the guide roller. Tighten and check the smoothness of rotation. Recheck the setup tags and make sure that the crankshaft is not cranked. You can quickly sell a car in Ukraine on the site AutoStock. The largest automarket Ukraine. Here you can find any car.

No comments:

Post a Comment