Polishing car windows with his hands

Various environmental factors, as well as the wipers left on car window tracks - minor scratches. In order to eliminate them and produce a polished car window. But this procedure requires patience and diligence. In fact, to polish the car window on their own will take approximately 2-3 thousand rubles, and it is much less than would have asked you to master. The process of polishing the car windows as follows: First, you must prepare to work the necessary tools and materials. Polishing are needed: a special powder that polishes automotive glass; circle polishing, polishing machine (suitable ordinary electric drill). Need a film to protect the body from contamination during the polishing process, as well as dry wipes (not diaper cloth) and a tool for cleaning windows (can be the one you use to wash windows and mirrors). Need masking tape, Squirtwoman and a marker. In order not to get dirty, you should wear clothing that is not necessary. When using a polishing machine to see what it develops momentum. This is quite important, as when polishing glass, speed of this device shall not exceed 1,700. If turnovers are higher, the glass can deform due to overheating. Before you begin, you must determine the extent and nature of damage. If the scratches are small, they easily succumb to polishing. But the chipped polish is strictly prohibited, since the result is a big crack. Chips must be eliminated before polishing. A well-polished before it is desirable to wash the whole car, and especially glass that you're going to polish. Dirt can cause other damage. After all this damage by a marker. Then the car is completely covered with foil, and on it, carefully cut out the "glass" car. Off the edges of the film to glue tape. Then the glass cleaner to remove any dirt. Polishing powder is diluted in water, but the weight should be thick. Fill with water Squirtwoman. Polishing process is as follows. Dense mass of powder is applied to the glass and the circle. Then the circle begin to gently polish the glass. Polishing powder should not dry up, so from time to time should be sprinkled with water the whole surface of the treated glass. Water will not allow also overheat the glass. The glass surface does not need to push hard. If you think that the glass is polished, then it should be cleaned and wipe dry with a cloth. Traces of the marker you can remove the ethanol. But the film from the car to shoot is not worth it, because if you notice that the glass still have scratches, the polishing process will have to produce again. On the whole, this process will take approximately 3 hours of time. But the cost of going to buy the necessary materials for polishing glass will be significantly less than the costs that would relate to the servicing of your car in specialized services.