Repair and maintenance of car Mazda 626

Repair and maintenance of wheel brakes on the car to car there are cases of leaking brake fluid from the cylinder rear brake drums. In order to fix this leak and repair the car, follow these steps: 1. Loosen the tightening of fastening the wheels to raise the car on the jack, put to insure the stand, remove the wheel; 2.Posle this removed the brake drum. For this pre-shot guides screwed screws into the holes with thread, and the effect is achieved puller. If this fails, resort to another option. Fixing by means of shims wheels that are on the ground, start the engine and the low gear at a slow rotation of the drum brake abruptly. At the same axis rotated in the opening of the drum and it is relatively easy to remove, 3. After the pickup drum to take off the tip of parking brake cable 4. After that the release of the reference panel of brake pads. For this purpose, remove the spring guide and are taken right up for the removal of shoes. To do this, first remove the lower spring, and then nominated the lower ends of the slots support pads and through them, performing a role in this arm is stretched taut over the top spring and the strap is removed and the brake pads themselves. At the same time trying not to damage the caps of the cylinder, made of rubber, 5. Begin to disassemble the brake cylinder, mounted on wheels. To do this, remove the protective cap and using a drift made of soft material vypressovyvayut from the cylinder pistons complete with details of the adjustment of the gap. With this operation, brake fluid poured on the ground. To save the liquid tube is disconnected from the wheel cylinder and jammed a wooden stopper. Further operations on disassembly of the cylinder are satisfied on the desktop. For this purpose, it is disconnected from the reference panel and disassemble. To do this, use a screwdriver, with which the piston produces rotation, eversion resistant screws and remove the cuffs with a supporting cup and biscuits. After that, disconnect the screw and the split ring 6. Removed parts carefully wiped and inspected. Parts that have found deterioration or roughness change; 7. Wheel cylinder assembly, staging and assembly of the brake mechanism in the reverse order.