Replacing the rear shock absorbers for the Mazda 3

To replace shock absorbers, we need the following tools: ~ Key and rattle on 17. ~ The key adjustable one. ~ The key to the 7. ~ Wd-40. ~ Clips for the spring. ~ Also available must have a 4-stop nut. The first thing we do is remove the trim from the trunk of a car. Car lift is not necessary, it would be superfluous. In the trunk there are special bolts to loosen them. They are easily removed without tools. Shock absorbers should be changed at a time, otherwise the brake hoses stretched to the limit. After raising the car with the jack or a special lift. Remove the wheel. The car must be raised to a level that would spring was relaxed. If after lifting the spring is still tense, most likely you have a great spring and will have to shoot it with clamps. Absorber from the bottom side is secured with the help of stop nuts. It must be processed WD-40. Further anchoring nut and rests it in the beam. There are occasions when the nut is very tight, the benefit under the wing enough space to use some sort of pipe as a lever. In the event, and so it does not work, there's another "recipe" removing bolts. Don key on the nut and lift the butt quickly using the jack, with drench the nut with a special solution. When removing the shock absorber under the wheel to enclose that some type of brick or block. This is necessary so that would nebylo useless movements and freewheel when removing the shock absorber. After removal of the nut, bolt is easily removed. The truth while removing it should not be. To begin, remove the stop-nut which is located nearby. With its removal problems should arise. When the nut is removed, remove shaybochku and rubber pad under it. Remember which side they fit with the axis. Now we can remove the bolt holding the shock absorber. He pulled out without much effort and without tools. Removing bumper mark which side he was in the mount, that is, where ended the spring. After you remove the spring, just remembering its position. With the shock absorber must be removed, two goals, one more than others, and gum. Remembering how they stood, it is important. Try not to lose the puck, otherwise ill have to. On some types of shock absorbers is the top cap, if it exists, it must also be removed. At that practically everything. When'll put new machines, washers, and put all the Gadget as well as filmed, the same parties, which they stood.