Replacing the stabilizer bar bushings on auto Toyota Camry

Stabilizer bar, which is used on this car is unique because it also serves to prevent longitudinal movement of the lower suspension arms. To replace the bushings of the stabilizer, there is no need to disconnect the stabilizer of the lower suspension arms. Withdrawal. Raise the car with the jack and attach the supports. Unscrew the two large nuts stabilizer to the lower arm, remove the holder. Unscrew the bolts and nuts crossbeam suspension, then lower the crossbeam. Loosen the clamp bolts shift control cable transmissions, then remove the central beam engine mounting. Unscrew the bracket lower arm from the body. Removing only with one hand. Remove the four bolts (after loosening the bolts of the first two prop stabilizer to prevent it from falling) U-shaped bracket stabilizer bar. Now remove the stabilizer from the lower lever (in the presence of spacers used between the arms and stabilizer, do not lose them). Replacement sleeves Remove U-shaped bracket with a stabilizer and the rubber sleeve oscillating motion. Then remove the rubber bushing with a stabilizer, and clean the socket sleeve to remove dust and rust. To facilitate the installation of new grease sleeve inside and out with vegetable oil (do not use lubricant on the basis of kerosene or minerals, as well as brake fluid - this will damage the sleeve). Install a new sleeve on the stabilizer, then insert the U-shaped bracket, using the oscillating motion in the presence of resistance. Installation. Replace the pads and holders, the ends of the stabilizer in the lower arms, set holders and new nut. Start tightening the nuts by hand is not fully tighten. Attach the bracket lower arm to the body and establishing a central beam engine mounting, tighten all connections. Set crossbeam suspension, and also tighten all connections. Place the transmission shift control cable and tighten the clamps. Install new bolts to the U-shaped bracket stabilizer, pre-tightening all four bolts. Tighten the U-shaped brackets. Lower the vehicle to the ground, tighten the two large nuts of the stabilizer to the lower arm. The highest-quality winter tires from Russian and foreign manufacturers. Here you will pick up any tire size, as well as high-quality cast and forged wheels.