Coloring stamped disc with his own hands

Die CD is, in many cases full-time drive. Its advantages are that it is not expensive, not garish and plastic. There are also disadvantages. Discs corrode, do not have a design idea and heavy. After painting stamped disc is one drawback - the weight. Geometric designs on the outer side of the disc, the possibility of using the color palette adds some attractive than those of bored cast. And pressed discs are protected from the devastating effects of the environment. There are several ways to make new clothes drives - is to resort to the help of professionals who, for a fee update the metal discs. First repairers otpeskostruyat discs will cause soil and stain after polymer paint and place a disc in an oven with temperatures up to 200oC. In theory, this process is called hammer effect. In practice, any non-skilled worker tire changer points to easily leave a few scratches on the disk, even with this technique of painting a hammer effect. Therefore, another method is most suitable for most motorists. This will depend on price and quality of selected materials, as well as the willingness and ability to motorist. Preparatory work new clothes drive is best done between seasons, autumn or spring. Need to start preparing a thorough cleaning of dirt, old paint t rust. Cleanup drive is best done using a metal brush - attachments for drills or grinders. Further, it is best to use medium and fine sandpaper to finalize the disk surface. Better to spend more time preparing than to suffer with the wheels constantly podkachivaya in the process of further exploitation. Work necessary to produce a protective mask or goggles, and preferably a respirator. After cleaning, rinse with water wheels and handle the rust converter. Please note that the converter begins to work on korrogirovaniyu 30 minutes after use and at an acceptable temperature. Environment. Degrease the surface of the disk white spirits after a couple of hours after use rust converter and let dry surface. Do not want to give great advice. Before starting to paint drive to dampen the floor with water, so as not to raise dust. Wheels set of 5-liter jerry cans filled with water. The primer cartridge before priming with the ground shake for 15 seconds and the best warm up before using it on battery or on the sun. Primed to drive several times, leaving 5 minute breaks between the layers. Then let it dry first coat within 24 hours. After, clue and bumps on the disk surface trimmed with fine nazhdachki and water. The disk surface should be ideal. Painting Paint over Disk 2-3 layers with intervals of 5 minutes. So, dyed discs. After an hour of rest and take avtolak from a distance of 35-40 cm causes a painted surface of the discs is similar, with breaks between the layers. Two or three layers avtolaka will be sufficient to protect the paint, but there is little nuance, avtolak gaining maximum strength by 9.8 days after application. Outcome Bottom line: cost to repair disks in specialized plants may be in the amount of $ 150-200, and repair disk stamped with his own hands can cost $ 35-40. Savings is also a kind of income!