Polishing a car body with their hands

So, before you start to learn the basics of the process of polishing the car with his own hands, you need to know that there are two kinds of polishing: defensive and abrasive. With regard to protective polish, then it is typical to use a variety of polishing pastes (Teflon, wax, etc.). This polished, in fact, necessary to protect the car body from a variety of factors from outside, but also makes the car looks newer. To achieve the desired effect, such polishing paste applied directly on the body of the car and spread evenly over the surface. However, this method of polishing is a major drawback: a covering of short-lived and eventually erased. Accordingly, a well-groomed and pleasant view of the car will give a polishing abrasive manner. Everyone who wants to "podrihtovat" my car just the way you need to know that such polishing is usually carried out gradually: Using a special "skins" for grinding to remove from the car body top layer of paint and polish the existing bumps and scratches. To obtain the most favorable outcome at this stage, the car can not be placed in the draft, and the dust, inflated as a result, may leave on the back of the machine unwanted scratches. Also, polishing the vehicle is not recommended in the sun, as this would lead to undesirable rapid drying polishing paste. Polishing the car body is expedient to perform with the grinding "skins" and a bar, pre-treating the surface with water. Once is obtained by the homogeneous structure of a matte surface, it is desirable to polish the surface without the application block. And, in general, if done sanding by hand (without using readily available materials), the efficiency of polishing process is increased, because the hand can feel the tiniest speck of dust, which can leave scratches on the car. To polishing results were satisfactory, it is necessary to remember that sanding should be done qualitatively and not to rush (to break large areas of the body into smaller, etc.). If the body color dark - to perform additional grinding to eventually become a uniform color and matte. Directly polishing the car. For this purpose, the desired portion is applied wax or with a special polishing machine feather paste on the surface. If the paper we use such a machine, it does not need to dramatically drive on the surface of the body, but rather gently horizontally and then vertically from the top. If polishing paste begins to dry out, can be slightly moisten the surface of the car, but not much, so you do not have to wash all the chinks in the vehicle. Thus, it is easy to see that polishing is not complex, but rather time-consuming process that must be taken seriously. Polishing process can largely hide the obvious flaws in the car body (scratches, dust, etc.), as well as give the vehicle a more recent and well-groomed appearance.