Rinse injector with their own hands

Currently, almost all modern machines (Auto) are used for fuel injection nozzles, which are called the injectors. When burned in any system formed combustion products, especially in the injector, regardless of the quality of gasoline used. Fuel, particularly gasoline, has such chemical compounds as sulfur, olefin and benzene, albeit in small quantities. At a pressure of about 3-5 atmospheres, as well as high temperature, about 70-90 degrees during compression, these compounds form deposits, which are virtually washed away, because they are dense and varnished. At the use of low-quality gasoline fuel systems contaminated much swifter and more powerful. That, in consequence, lead to lower efficiency motor. When the injector is polluted, it reduces the performance, shape and orientation of jet spray did not meet specifications. This can lead to a stop the engine. This reduces the term of the lambda probe and catalyst. Reduced engine power, it becomes less acceleration. Since the discontinuity of the engine is idling, when overclocking failure, as well as an increase in emissions control are the true features that need to be spent washing the injector, or replace it. For example, in Europe are very high quality gasoline and therefore do not need to resort to cleaning the injector. Although the run of 100-150 thousand, manufacturers recommend changing. In the CIS, mileage is reduced approximately ten times and is about ten thousand due to the fact that the lower efficiency of the injector, respectively, need replacing or cleaning. In the cold period, when temperatures still quite low, the evaporation of gasoline is much less. As a result, cold engine runs a lot longer observed discontinuity in its work. When choosing a method of cleaning the injector should pay attention to the large number of moments. For example, the degree of contamination or wear of the engine. The easiest and best way is to use a cleaning additive. Value, the cleaning liquid in a ratio of 250-350 grams of 50-70 liters. Then when driving car in cruise mode, the existing pollution dissolve. That is why this treatment should be carried out after every 3-5 thousand miles. This method is more on prevention. It is used only to maintain the purity of the injector or the entire fuel system. If the pollution is more severe, then this method can damage, clog more injector and fuel pump. Then apply a more substantial measures. To wash the injector use special installation of the liquid. In this case, it is not removed from the machine. If washing does not include fuel pump, fuel tank, a wired system and a filter. Then include the engine. It runs on gasoline, along with cleaning liquid for about an hour. She served at a pressure of 2.5 atmospheres of the installation is run through a muddy dirt nozzle and burns in the cylinders. All that remains of the drilling fluid can be removed when the engine is in extreme mode. Next, you need to change the oil filter.