Repair their own hands car VAZ

If suddenly there was a knock on the steering rack VAZ, there is no need to immediately run to the station. All steering gear failure can establish their own hands. Only when independent work is necessary to be careful, very careful. To ensure security is tightened the hand brake, steering lock is made, as well as stops are located under the rear wheels. Still need to remove the negative terminal of the battery output. The work begins with the removal of the front wheels. To do this, use the jack. Then removed rod ends, with a special extractor. Nut clamps, through which the steering rack is attached to the body of the machine, you need to unscrew. To do this, apply a liquid WD - 40, which will facilitate your work. Then, using a flashlight to illuminate the portability, it is necessary to unscrew a bolt, which is located on the steering shaft is almost near the floor. And extract the steering rack after disconnecting from the tail shaft spline gears. Retrieved via rail, placed on the right hole. Then go in and apply a large bench vise. In order to clean the top rack, you need to take a cloth that is impregnated with white spirit, and a wire brush. To carry out such a procedure is required purity. After cleansing the body, to loosen the bolts that hold the mustache. Silent blocks an inspection to assess the possibility of further exploitation. After that we remove his mustache. To do this, turn down the plate and remove the bolts. At the end of the body are rubber plugs, remove them. Removed and the rubber cushion and rubber from the shaft gear. Using a screwdriver, removed from the bearing lock washer, and unscrew the nut. Together with the pinion bearing is removed. In order to do this, you must hold down the splined shaft and tap with a hammer to the body rails. Parts that were removed, washed in white spirit. Once all the parts cleaned, set it aside. And take out from the housing rack. In the absence of signs of wear on the rail, it washed, dried and then applied the new grease. Next, take out through the slot in the housing plastic sleeve, using a screwdriver. But be very careful that whatever hook and not to damage the aluminum landing a plane. If the damage aluminum nuts, you should immediately replace it. Lugs on the cover and mustache require scrutiny. If, as a result of testing on your fingers tips, were not found backlash, they can not be changed. After the inspection and rejection of superfluous details, finally, you can begin to build rail. Begin with the installation of a new plastic sleeve into the body rails, while acting absolutely must be in the slots. Set the rack on the side where the gear is located. With kolumbika, set the distance from the end rails to the body, it must be equal to 28 mm. Then put in place gear and pressed into the bearing until it stops. Then return to the place of focus and a spring, spinning lock nut. Next, put in place all the remaining parts, rubber boots. All operations were performed carefully to avoid damage. With the help of clamps attach a cover rail. By bringing all rail, put in place, connect the steering shaft coupling to the shaft, which is on the gear. Finished. Now, eat and check the geometry.